All glue detector systems are monitored and run by a 12“ Touch screen. A data analyser, an encoder frequency divisor and a stroboscopic illuminator are installed inside an electrical cabinet.
Black & White camera 640X480 pixels resolution, 60 frames/second and 32 high efficiency led stroboscopic camera illuminator.
- Maximum speed with 1 connected camera: 350 m/min.
- Maximum speed with 2 connected camera: 290 m/min.
- Maximum speed with 3 connected camera: 230 m/min.
- Maximum speed with 4 connected camera: 180 m/min.
A well glued box must be run under the glue detection camera, and through an auto-learning system, the device takes a picture of this good sample. This sample is a box with a correct gluing pattern accepted by the operator. The picture of this glued box will be memorized and constantly compared by the system to all other boxes which run through the machine. The glued box acquired through the auto-learning system will be the sample to which all other boxes must be compared. If other glued boxes which run through the machine are not the same in terms of volume and / or position, as the accepted sample, the system will recognise these different boxes as faulty. This means the glue pattern must be exactly the same on each produced box within the tolerance frame. After the recognition of faulty boxes the glue detection system is able to mark them using specific devices.
Specification and tollerances
Smallest readable dot = Ø1.5 at 200 meters/minute.
Adjustable tolerance threshold to measure whether glue levels are too low or too high.
Adjustable tolerance threshold for shifted glue pattern position at the beginning or at the end of glue patterns (Min. tolerance = 1mm).
- Extractor for small boxes
- Marker and its gun GTE-10